1997 MERCURY SABLE 4DR SEDAN
Security
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU(+) (-) DRIVERS KICK OR LT.GRN/ORN(-) AT LHT SW
TrunkTrigger BLK/PNK (-) (-) AT TRUNK LIGHT
HoodTrigger N/A
FactoryAlarmDisarm PNK/WHT (-) DRIVER'S KICK PANEL
ParkingLights BRN (+) DRIVER'S KICK PANEL OR FUSEBOX
Remote Start
Battery YEL + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 GRY/YEL + (+) IGNITION SWITCH HARNESS (BLOWER MOTOR)
Ignition03 RED/BLK + IGNITION SWITCH HARNESS (FOR A.C.)
Accessory01 RED/LT.BLU + (+) IGN.SW.HARNESS (HEAT A.C.)
Accessory02 +
Starter01 RED/LT.BLU + (+) IGNITION SWITCH HARNESS
AntiTheftType RF ACTIVATED SYS.
AntiTheftSystem PATS
KeySense BLK/PNK (-) (-) IGNITION SWITCH HARNESS
NeutralSafety NOT GROUNDING OEM SWITCH OPENS STARTER CIRCUIT
Tach YEL/BLK (-) (-) AT MULTI COIL PACK
SpeedSense GRY/BLK (AC) DRIV.STRUT TOWER,10 PIN PLUG,PIN 3
ParkingLights BRN (+) DRIVER'S KICK PANEL OR FUSEBOX
BrakeLights RED/GRN (+) AT BRAKE SWITCH
ReverseLights BLK/PNK (+) (+) AT SWITCH ON TRANSAXLE
Horn VIO/ORG (-) AT STEERING COLUMN 4 PIN PLUG"
Doorlocks / Window
PowerUnLock PNK/GRN (-) (-) NEGATIVE TRIGGER
PowerLock PNK/YEL (-) (-) DRIVER'S KICK PANEL BELOW FUSEBOX
LeftFrontWindow01 LF:BLK/WHT
RightFrontWindow01 RF:WHT/YEL LR:YEL/BLU RR:YEL/BLK
LeftRearWindow01 LF:TAN/LT.BLU
RightRearWindow01 RF:TAN/BLU LR:GRY/ORG RR:RED/BLK
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
TrunkRelease GRY/RED (-) AT SWITCH OR DRIVERS KICK PANEL
Mobile Audio / Video
Battery YEL + (+) IGNITION SWITCH HARNESS
Accessory01 RED/LT.BLU + (+) IGN.SW.HARNESS (HEAT A.C.)
Ground -
FrontLeftSpeakerPos ORG/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos GRY/LT.BLU
RearLeftSpeakerNeg TAN/YEL
RearRightSpeakerPos ORG/RED
RearRightSpeakerNeg BRN/PNK
Amp LEFT TRUNK PANEL
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
